Search Results: "icx 7450"

MACsec configuration and secure channel activity for a particular interface. The following show macsec statistics command output is for an ICX 7450 device. device# clear macsec statistics ethernet 10/2/1 device# show macsec statistics ethernet 10/2/1 Interface Statistics: --------------------- rx

MACsec configuration and secure channel activity for a particular interface. The following show macsec statistics command output is for an ICX 7450 device. device# clear macsec statistics ethernet 10/2/1 device# show macsec statistics ethernet 10/2/1 Interface Statistics: --------------------- rx

snooping address limits apply to RUCKUS devices: ICX 7250 devices support 8192 IGMP snooping group addresses. ICX 7450 devices support 8192 IGMP snooping group addresses. ICX 7650 switches support 8192 IGMP snooping group addresses. ICX 7750 routers support 6K IGMP snooping group addresses. The no

Campus Fabric Layer 3 unicast considerations Campus Fabric Layer 3 unicast considerations Campus Fabric Layer 3 unicast considerations The following table lists Layer 3 unicast features available in a Campus Fabric domain for ICX 7150, ICX 7250, or ICX 7450 devices enabled as PE units. Layer 3

Command history 08.0.20 This command was introduced. 08.0.30 Support for this command was added on ICX 7450 devices. 08.0.70 Support for this command was added on ICX 7650 devices. 08.0.90 Support for this command was added on ICX 7850 devices.

this command was added on ICX 7450 devices. 08.0.70 Support for this command was added on ICX 7650 devices. 08.0.90 Support for this command was added on ICX 7850 devices.

no optical-monitor non-ruckus-optic-enable Optical transceivers are not monitored. alarm-interval Specifies the interval at which alarms and warning messages are sent. The default and minimum timer for ICX 7450, ICX 7550, ICX 7650, RUCKUS ICX 7750, and ICX 7850 devices is 8 minutes. The default

configuration mode This command is supported only on Ruckus ICX 7250 ICX 7750, and ICX 7450 devices. This command is not supported on Ruckus ICX 7150 or ICX 7650 devices. To enable global PFC, symmetrical-flow-control (SFC) must be disabled. You must enable PFC globally before you configure it for

, ICX 7550, ICX 7450, and ICX 7250 considerations Per-interface level configuration is available on VE interfaces and physical ports only. IPv4 and IPv6 unicast routed packets are subjected to uRPF check on ICX 7850, ICX 7750, and ICX 7650 devices. Scaling numbers are reduced by half for the following

Number of ECMP Load Sharing Paths per Device ICX 7150 / ICX 7250 / ICX 7450 / ICX 7550 ICX 7650 / ICX 7750 / ICX 7850 8 32 For optimal results, set the maximum number of paths to a value at least as high as the maximum number of equal-cost paths your network typically contains. For example, if the