Search Results: "icx 7450"

traffic suppression on a route-only port. Ruckus ICX 7450, ICX 7250, ICX 7750, and RUCKUS ICX 7150 devices support only ingress L2 traffic suppression on a route-only port. RUCKUS ICX 7150 devices support only ingress L2 traffic suppression on a route-only port. To disable Layer 2 switching only on a

Command history 08.0.20 This command was introduced. 08.0.30 Support for this command was added on ICX 7450 devices. 08.0.70 Support for this command was added on ICX 7650 devices. 08.0.90 Support for this command was added on ICX 7850 devices.

this command was added on ICX 7450 devices. 08.0.70 Support for this command was added on ICX 7650 devices. 08.0.90 Support for this command was added on ICX 7850 devices.

suppression on a route-only port. Ruckus ICX 7450, ICX 7250, ICX 7750, and RUCKUS ICX 7150 devices support only ingress L2 traffic suppression on a route-only port. To disable Layer 2 switching only on a specific interface, go to the interface configuration level for that interface, and then

ICX 6610, ICX 7750, and ICX 7450 devices support enabling ports in either Layer 2, Layer 3, or Layer23 mode. OpenFlow is supported on Breakout ports on ICX 7750. OpenFlow match rules Match rule on Brocade device Port enabled for Layer 2 mode Yes Source port Yes Source or destination MAC address Yes

ECMP Load Sharing Paths per Device ICX 7150 / ICX 7250 / ICX 7450 / ICX 7550 ICX 7650 / ICX 7850 8 32 For optimal results, set the maximum number of paths to a value at least as high as the maximum number of equal-cost paths your network typically contains. For example, if the Layer 3 switch you are

, ICX 7450, and ICX 7250 Considerations Per-interface level configuration is available on VE interfaces and physical ports only. IPv4 and IPv6 unicast routed packets are subjected to uRPF check on ICX 7850 and ICX 7650 devices. Scaling numbers are reduced by half for the following system values when

Command history 08.0.20 This command was introduced. 08.0.30 Support for this command was added on ICX 7450 devices. 08.0.70 Support for this command was added on ICX 7650 devices. 08.0.90 Support for this command was added on ICX 7850 devices.

this command was added on ICX 7450 devices. 08.0.70 Support for this command was added on ICX 7650 devices. 08.0.90 Support for this command was added on ICX 7850 devices.

MACsec configuration and secure channel activity for a particular interface. The following show macsec statistics command output is for an ICX 7450 device. device# clear macsec statistics ethernet 10/2/1 device# show macsec statistics ethernet 10/2/1 Interface Statistics: --------------------- rx