Search Results: "icx 7450"

routing (PBR). Ruckus ICX 7450 supports dynamic routing of traffic over an IPsec tunnel by using routes learned by way of Routing Information Protocol (RIP) or Open Shortest Path First (OSPF). Because IPsec tunnels are established by using virtual tunnel interfaces (VTIs), they can plug into the routing

routing (PBR). Ruckus ICX 7450 supports dynamic routing of traffic over an IPsec tunnel by using routes learned by way of Routing Information Protocol (RIP) or Open Shortest Path First (OSPF). Because IPsec tunnels are established by using virtual tunnel interfaces (VTIs), they can plug into the routing

frames received with the specific source MAC address and destination MAC address are looped back. Skip this step to configure flow-unaware mode. On ICX 7450 and ICX 7250 devices, configuring the ethernet loopback test-mac command is mandatory because these devices support only flow-aware mode. device

, ICX 7650, ICX 7450, and ICX 7250 devices. num Specifies the time, in multiples of 60 seconds, the device should wait before stopping traffic to a port when a leave message is received The range is 60 through 3600 seconds, in multiples of 60. Global configuration mode The no form of this command

Campus Fabric Scalability Campus Fabric Scalability Campus Fabric Scalability A Campus Fabric domain can contain from 1 to 4 CB units. Each of the CB units can support a PE chain or ring of up to 6 units. The maximum number of PE units in a Campus Fabric domain is 36. Assuming 48-port ICX 7450, ICX

Campus Fabric scalability Campus Fabric scalability Campus Fabric scalability A Campus Fabric domain can contain from 1 to 4 CB units. Each of the CB units can support a PE chain or ring of up to 6 units. The maximum number of PE units in a Campus Fabric domain is 36. Assuming 48-port ICX 7450, ICX

configuration mode PE configuration mode The command is available only on the ICX 7450, and only after the spx pe-enable command has been entered. That is, the command is available only on a PE or a provisional PE unit; it is not available from the control bridge (CB). The suggested ID does not

default, the device monitors the local CPU port for control packet drops. However, you can configure the device to monitor a different port for packet drops. On the RUCKUS ICX 7250, ICX 7450, ICX 7850, and ICX 7550 devices, each port has its own set of drop counters. This task is supported only on the

following platforms: RUCKUS ICX 7850 (standalone, stacking and SPX stack configuration) RUCKUS ICX 7750 (standalone, stacking and SPX stack configuration) RUCKUS ICX 7650 (standalone, stacking and SPX stack configuration) RUCKUS ICX 7550 (standalone, stacking and SPX stack configuration) RUCKUS ICX 7450 (standalone

connected to the CB in a chain or ring can be ICX 7450, ICX 7250, ICX 7150 units, or a mix of these units. Multicast E-CID and IEE 802.1BR The point-to-multipoint E-channels used for remote replication are identified by an E-CID with a value in the range of 0x1000 to 0x3FFF (values less than this are reserved for E-CIDs associated with point-to-point E-channels).