Search Results: "icx 7850"

that you do not change the denominator to a value lower than the default. Sampling requires CPU resources. Using a low denominator for the sampling rate can cause high CPU utilization. On RUCKUS ICX 7750, ICX 7450, ICX 7250, ICX 7650, ICX 7850, and ICX 7550 the CPU-bound sFlow sample packets are

OID to get the current forwarding profile from ICX 7850 and ICX 7550 devices. Refer to Forwarding Profile table. FlexAuth MIB Added new OIDs for web authenticaton login page. Refer to FlexAuth Web Authentication Configuration for the newly added OIDs. Key Features and Enhancements in FastIron

sessions to come up. For multi-unit LAGs, it is recommended to use Micro-BFD. Multi-hop BFD is not supported if micro-BFD is enabled. BFD is supported for ICX 7850 platforms. In a stack setup, a BFD session is programmed on the unit where the tx-port is present. Incoming BFD packets must be received

sessions to come up. For multi-unit LAGs, it is recommended to use Micro-BFD. Multi-hop BFD is not supported if micro-BFD is enabled. BFD is supported for ICX 7850 platforms. In a stack setup, a BFD session is programmed on the unit where the tx-port is present. Incoming BFD packets must be received on

sessions to come up. For multi-unit LAGs, it is recommended to use Micro-BFD. Multi-hop BFD is not supported if micro-BFD is enabled. BFD is supported for ICX 7850 platforms. In a stack setup, a BFD session is programmed on the unit where the tx-port is present. Incoming BFD packets must be received

for ICX 7150 devices. The default alarm interval for ICX 7150 is 3 minutes. device(config)# optical-monitor Enabled optical monitoring and set alarm/warn interval to default(3 minutes) The default alarm interval for ICX 7550, ICX 7650, ICX 7850, and RUCKUS ICX 8200 devices is 8 minutes. device

the live connections between two units, physically remove the unwanted cables first. Then configure the multi-stack-port or multi-stack-trunk command to change both ends of the live link at the same time. For example, suppose you have an ICX 7850 stack with a live link stack-trunk 1/2/1 to 1/2/4

the live connections between two units, physically remove the unwanted cables first. Then configure the multi-stack-port or multi-stack-trunk command to change both ends of the live link at the same time. For example, suppose you have an ICX 7850 stack with a live link stack-trunk 1/2/1 to 1/2/4

-trunk configuration. To reduce the live connections between two units, physically remove the unwanted cables first. Then configure the multi-stack-port or multi-stack-trunk command to change both ends of the live link at the same time. For example, suppose you have an ICX 7850 stack with a live link

-monitor Enable optical monitoring and set alarm/warn interval to default(8 minutes) The default alarm interval for the ICX 7450, ICX 7550, ICX 7650, and ICX 7850 is 8 minutes. The default alarm interval for the ICX 7250 and ICX 7150 is 3 minutes. Ports that are down are not included for optical