RUCKUS Device MIBs

  • Parent node: ruckusDeviceInfo
  • OID: .1.3.6.1.4.1.25053.1.1.4.1.1.1

Node Name

OID

Description

Access Permission
ruckusDevicename .1.3.6.1.4.1.25053.1.1.4.1.1.1.1 Shows the device name. Read-Write
ruckusDeviceReboot .1.3.6.1.4.1.25053.1.1.4.1.1.1.2 Initiates device reboot. Read-Write
ruckusDeviceRebootWithDefaults .1.3.6.1.4.1.25053.1.1.4.1.1.1.3 Shows the product to revert to factory defaults. Read-Write
ruckusDeviceCountryCode .1.3.6.1.4.1.25053.1.1.4.1.1.1.4 Shows the AP country code. Read-Write
ruckusDeviceGPS .1.3.6.1.4.1.25053.1.1.4.1.1.1.5 Shows the GPS Location. Read-Write
ruckusDeviceLedCtrl .1.3.6.1.4.1.25053.1.1.4.1.1.1.15 Shows the ON or OFF state of the device control led. Read-Write
ruckusDeviceLocation .1.3.6.1.4.1.25053.1.1.4.1.1.1.10 Shows the location of the device. Read-Write
ruckusDeviceMacAddr .1.3.6.1.4.1.25053.1.1.4.1.1.1.11 Shows the device MAC address. Read only
ruckusDeviceNEID .1.3.6.1.4.1.25053.1.1.4.1.1.1.6 Shows the device NE ID. Read-Write

  • Parent node: ruckusDeviceTrapInfo
  • OID: .1.3.6.1.4.1.25053.1.1.4.1.1.2

Node Name

OID

Description

Access Permission
ruckusDeviceTrapDestination .1.3.6.1.4.1.25053.1.1.4.1.1.2.1 Specifies whether the primary trap destination is an IPv6 or IPv4 address. Read-Write
ruckusDeviceTrapDestination2 .1.3.6.1.4.1.25053.1.1.4.1.1.2.2 Specifies whether the secondary trap destination is an IPv6 or IPv4 address. Read-Write

  • Parent node: ruckusDeviceIPInfo
  • OID: .1.3.6.1.4.1.25053.1.1.4.1.1.3

Node Name

OID

Description

Access Permission
ruckusDevicePrimaryDNS .1.3.6.1.4.1.25053.1.1.4.1.1.3.1 Shows the primary DNS address. Read-Write
ruckusDevicePrimaryDNSIPV6 .1.3.6.1.4.1.25053.1.1.4.1.1.3.3 Shows the primary DNS IPv6 address. Read-Write
ruckusDeviceSecondaryDNS .1.3.6.1.4.1.25053.1.1.4.1.1.3.2 Shows the secondary DNS IP address. Read-Write
ruckusDeviceSecondaryDNSIPV6 .1.3.6.1.4.1.25053.1.1.4.1.1.3.4 Shows the secondary DNS IPv6 address. Read-Write

  • Parent node: ruckusDeviceWanInfo
  • OID: .1.3.6.1.4.1.25053.1.1.4.1.1.4

Node Name

OID

Description

Access Permission
ruckusDeviceWanTable .1.3.6.1.4.1.25053.1.1.4.1.1.4.1 Shows the WAN table. Not accessible
ruckusDeviceWanEntry .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1 Shows the WAN entry. Not accessible
ruckusDeviceWanGateway .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.5 Shows the gateway IP address if the ruckusDeviceWanIPAddrMode is set to static(2). Read-Write
ruckusDeviceWanIPAddr .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.2 This is writable only if the ruckusDeviceWanIPAddrMode is set to static(2). Read-Write
ruckusDeviceWanIPAddrMode .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.1 The following values specify the modes through which the WAN obtains the IP address:

none - by bridging

static - through statically assigned IP address

dhcp - using the DHCP protocol

pppoe - using the PPPoE protocol

When the ipaddr mode is changed from dhcp to static, the relative nodes must be set together, including ruckusDeviceWanIPAddr,ruckusDeviceWanNetmask and ruckusDeviceWanGateway.

 Read-Write
ruckusDeviceWanIPIndex .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.200 Shows the interface index. Read only
ruckusDeviceWanIPV6Addr .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.11 This is writable only if the ruckusDeviceWanIPAddrMode is set to static(2). Read-Write
ruckusDeviceWanIPV6AddrMode .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.10 The following values specify the modes through which the WAN obtains the IPv6 address:

auto-configuration - through RFC

static - through statically assigned IPv6 address

When the ipv6addr mode changes from auto-configuration to static, the relative nodes should be set together including ruckusDeviceWanIPV6Addr, ruckusDeviceWanIPV6PrefixLen, and ruckusDeviceWanIPV6Gateway. 		Read-Write
ruckusDeviceWanIPV6Gateway .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.13 Specifies the gateway IPv6 address if the ruckusDeviceWanIPV6AddrMode is set to static(2). Read-Write
ruckusDeviceWanIPV6PrefixLen .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.12 Specifies the prefix length of the IPv6 address if the ruckusDeviceWanIPV6AddrMode is set to static(2). Read-Write
ruckusDeviceWanIPVersion .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.8 The following values specify the system IP address version.

ipv4 - only supports IPv4 addressing

ipv6 - only support IPv6 addressing

dualstack - supports IPv4 and IPv6 addressing

 Read-Write
ruckusDeviceWanName .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.3 Shows the name of the WAN interface. Read only
ruckusDeviceWanNetmask .1.3.6.1.4.1.25053.1.1.4.1.1.4.1.1.4 Specifies the IP address mask if the ruckusDeviceWanIPAddrMode is set to static(2). Read-Write
Parent topic: RUCKUS AP MIBs