Find Technical Content
  • Home
  • Ruckus Support Portal
  • Ruckus Networks
  • Table of Contents
  • Dark Mode

Powered by Titania Delivery

⚠ This cached page may be outdated. Click refresh to get the latest content.
Cached Version You are Offline

You are viewing a cached version of this page.

You are currently offline. This page was loaded from cache.

RUCKUS IoT Controller Software Installation Guide, 2.2.1.0 MR 800-73588-001 Rev A

  • Preface Ruckus
    • 3 Contact Information, Resources, and Conventions
      • 3.1 Document Conventions
      • 3.2 Command Syntax Conventions
      • 3.3 Document Feedback
      • 3.4 RUCKUS Product Documentation Resources
      • 3.5 Online Training Resources
      • 3.6 Contacting RUCKUS Customer Services and Support
  • 4 About This Guide
    • 4.1 Introduction to RUCKUS IoT Controller
    • 4.2 What's New in This Document
  • Installing vRIoT on a Hypervisor
    • 5 Installing RUCKUS IoT Controller on Hypervisor
      • 5.1 System Requirements for Installing RUCKUS IoT Controller on a Hypervisor
      • 5.2 Installing RUCKUS IoT Controller on a VMware ESXi
      • 5.3 Installing a KVM Guest Using virsh Commands
      • 5.4 Installing a KVM Guest Using Virtual Machine Manager
      • 5.5 Installing RUCKUS IoT Controller on Hyper-V
  • 6 Upgrading the Software
    • 6.1 Upgrading the AP Firmware Using SmartZone 100 or Virtual SmartZone Controller
  • 7 Hot Upgrade of IoT Gateway
  • 8 Deploying the APs
    • 8.1 Connecting a Set of IoT APs Using a Grouping Method
  • 9 Managing a License
    • 9.1 Activating a License

Upgrading the Software

In this section:

  1. Upgrading the AP Firmware Using SmartZone 100 or Virtual SmartZone Controller
    You can upgrade the existing AP firmware using a SmartZone 100 controller or Virtual SmartZone.

Did you find what you were looking for?

Thanks!

Ruckus Wireless

© 2026 Ruckus Wireless LLC All rights reserved.

  • Accessibility
  • Privacy & Cookies
  • Do Not Sell My Information
  • Trademarks
  • Terms
  • Feedback