RESTCONF Supported Modules

The following features are targeted for this release, but only a subset of the equivalent CLIs for each feature will be supported.

Note: For the initial release of RESTCONF for ICX, these are the features supported, and even for these features, not all functionality is supported.

List of Supported ICX Features

ICX Feature Openconfig Model
Interface/Port Config/Operational state
AAA Config
ACL Config
Archive Files Config
ARP Inspection Config
BPDU Guard Config
Boot Config
CLI Templates Config
Collected SNMP Configuration Config
Configuration File Upload and Download Operations Config
DAI Config
Default-Gateway Address on Management VLAN Config
Default VLAN Config
DHCP Config
DHCPv4 Snoop Config
DHCPv6 Snoop Config
DNS Config
Ethernet Config
Firmware Config
Flexauth Config
Forwarding Profile Config
Hostname Config
ICX Health Check and Get Switch Mode Config
IP Address on Management Interface Config
IP Default Gateway Config
IP Route Table Config
IP Voice VLAN Config
IPv6 Address on Management Port Config
IPv6 Neighbor Inspection Config
IGMP Snooping Config
Inline Power Priority Config
IPSG Config
IPv6SG Config
Jumbo Frame Config
LAG Config
LLDP-MED Config
Logging Host Config
MAC Address Table (Static and Dynamic) Config
Management VLAN Config
NTP Config
OSPF Config
Ping Config
Port-name on VE Interface Config
Protected Port Config
Provision Backup Restore Config
PVST Config
Reload Config
RSTP Config
SNMP Config
Source Guard Config
Spanning Tree Admin-edge Port Config
Spanning Tree Root Protect Config
Stacking Config
Static Route Config
Storm Control Config
STP Config
Supportsave Config
Tagged/Untagged LAG under VLAN Config
Traceroute Config
Trunk VLAN and Access VLAN Config
VE Config
VXLAN and VXLAN Tunnel Endpoints (VTEP) Config
Web Authentication Config
Write Memory Config