Deploying the Virtual Appliance Using Hyper-V Manager

To deploy the Virtual Appliance using Hyper-V Manager, perform the following steps:
  1. Open Hyper-V Manager.
  2. From the Action menu, select New > Virtual Machine.
    The New Virtual Machine Wizard opens.
  3. Read the Before You Begin screen.
  4. In the Name field, enter a name for the new virtual machine (VM), and click Next.
  5. Select Generation 1, and click Next.
  6. Assign Startup memory.
    Note: When using the New Virtual Machine Wizard, RAM is specified, but the system assigns only one virtual processor, by default. You can increase the number of virtual processors after completing the initial setup.
    • For software trials, feature testing, and other non-production systems, we recommend using 6 GB (6144 MB) RAM and two virtual processors.
    • For production systems with 4,000 or fewer users, we recommend using 8 GB (8192 MB) RAM and four virtual processors.
    • For production systems with 8,000 or fewer users, we recommend using 12 GB (12,288 MB) RAM and eight virtual processors.
    • For production systems with more than 8,000 users, we recommend using 16 GB (16,384 MB) RAM and eight virtual processors.
    • For production systems with more than 20,000 users, we recommend using 20 GB (20,480 MB) RAM and eight virtual processors.
  7. Leave Use Dynamic Memory selected (the default) and click Next.
  8. On the Configure Networking screen, select the appropriate virtual switch in the Connections field. Click Next.
  9. On the Connect Virtual Hard Disk screen, select Use an existing virtual hard disk and browse to the location where the VHDX file exists. Click Next.
  10. Verify the setup summary and click Finish.
    The system creates the new virtual machine.
  11. Edit the new virtual machine settings before you power it on. Complete the following advanced configuration steps to edit settings of the virtual machine.
    1. Using the Hyper-V Manager, right-click on the name of your new virtual machine and click Settings.
    2. Expand Network Adapter click Advanced Features.
    3. Under MAC Address, change the MAC address assignment from Dynamic to Static.
    4. Enter a MAC address within the range 02-15-5D-01-80-00 through 02-15-5D-01-8F-FF (for example, 02-15-5D-01-8A-BC).
    5. Click Apply and then click OK to close the Advanced Features window.
    Note: Microsoft recommends using a manually assigned static MAC address within this range.