Find Technical Content
  • Home
  • Ruckus Support Portal
  • Ruckus Networks
  • Table of Contents
  • Dark Mode

Powered by Titania Delivery

⚠ This cached page may be outdated. Click refresh to get the latest content.
Cached Version You are Offline

You are viewing a cached version of this page.

You are currently offline. This page was loaded from cache.

Cloudpath Enrollment System Replication Configuration Guide, 5.5 800-72419-001 Rev A

  • 3 Introduction
  • 4 Replication Topologies
  • 5 Prerequisites
  • 6 Configuring Replication
    • 6.1 Configuring an Active - Standby Replication
    • 6.2 Configuring an Active - Active Replication
  • 7 Monitoring the Cluster
  • 8 Running Replication Diagnostic Tests
  • 9 Repairing the Cluster
  • 10 Tearing Down the Cluster
  • 11 Upgrading the Cluster
  • 12 Replication Commands

Configuring Replication

Cloudpath supports two types of replication. Proceed to the applicable topic:

  • Configuring an Active - Standby Replication
  • Configuring an Active - Active Replication

In this section:

  1. Configuring an Active - Standby Replication
    You can configure a two-node, active - standby replication, which uses a virtual IP address.
  2. Configuring an Active - Active Replication
    You can configure a two-node active - active replication, which requires a load balancer.

Did you find what you were looking for?

Thanks!

Ruckus Wireless

© 2026 Ruckus Wireless LLC All rights reserved.

  • Accessibility
  • Privacy & Cookies
  • Do Not Sell My Information
  • Trademarks
  • Terms
  • Feedback