Deploying the Virtual Appliance Using a Console-Based VMware Client
Before you begin, read the list of information required to setup the system.
- Open a console for the VM.
- Enter yes (or y) to accept all license agreements.
- Enter the time zone. For example, enter America/Denver.
- Enter the FQDN hostname for the virtual appliance (ex., onboard.company.com).
- Do you want to enable HTTPS? Enter for yes (default) or n.
- Do you want to use a STATIC IP (rather than DHCP)?
Enter for yes (default) or
n.
- If you enter yes (recommended), you assign the IP address of the virtual appliance, subnet mask, and gateway and DNS server IP addresses for your network.
- If you enter no, DHCP is used to assign IP address of the virtual appliance eth0 interface, subnet mask, gateway, and DNS server IP addresses for your network. If you are not using DHCP, enter the IP address of the virtual appliance eth0 interface.
- Enter the IP address of the virtual appliance.
- Enter a subnet mask in the format 255.255.252.0.
- Enter the gateway IP address for your network.
- Enter the DNS server IP address.
- Do you want to permit SSH access? Enter for yes (default) or n.
- Enter and confirm a service password.
- Do you want to use an NTP server other than pool.net.org?
Enter for no (default) or
y to specify an NTP server.
The setup is complete.
- Press Enter to reboot the system.