Configuring an Onboarding SSID for Hotspot 2.0 R1

An onboarding SSID is required for Hotspot 2.0 Release 1.
  1. In the Controller UI, go to Wireless LANs.
  2. Be sure to highlight the zone where you want to add the onboarding SSID. This example uses the Default zone.

    Highlighting the Zone in Which to Create the Onboarding SSID

  3. Click Create.
    The Create WLAN Configuration screen appears. An example of how you configure this screen follows:

    Creating a Hotspot 2.0 Onboarding SSID

  4. In the Name field, enter a descriptive name for the onboarding SSID.
  5. From the Zone drop-down list, make sure the correct zone for your onboarding SSID is selected.
  6. From the WLAN Group drop-down list, make sure that you select the WLAN group where the onboarding SSID resides.
  7. For Authentication Type, select Hotspot (WISPr).
  8. For Authentication Method, select Open.
  9. For Encryption Method, select None.
  10. From the Hotspot (WISPr) Portal drop-down list, select the hotspot portal you previously configured.
  11. For the Authentication Server, be sure the corresponding button is ON, then select the authentication server from the drop-down list that you configured while you were setting up the Identity Provider.
  12. For the Accounting Server, you can optionally set the corresponding button is ON, then select the accounting server from the drop-down list if you configured one while you were setting up the Identity Provider.
  13. Use the default values for the remaining fields, and click OK.