relative-utilization

Configures uplink utilization lists that display the percentage of a given uplink port's bandwidth that is used by a specific list of downlink ports.
Syntax
relative-utilization number uplink ethernet stack-id/slot/port [ to stack-id/slot/port | [ ethernet stack-id/slot/port to stack-id/slot/port | ethernet stack-id/slot/port ] ... ] downlink ethernet stack-id/slot/port [ to stack-id/slot/port | [ ethernet stack-id/slot/port to stack-id/slot/port | ethernet stack-id/slot/port ] ... ]
no relative-utilization number uplink ethernet stack-id/slot/port [ to stack-id/slot/port | [ ethernet stack-id/slot/port to stack-id/slot/port | ethernet stack-id/slot/port ] ... ] downlink ethernet stack-id/slot/port [ to stack-id/slot/port | [ ethernet stack-id/slot/port to stack-id/slot/port | ethernet stack-id/slot/port ] ... ]
Command Default

Relative utilization is not configured.

Parameters
number
Specifies the list number. The value can range from 1 to 4. You can specify upto four lists.
uplink ethernet stack-id/slot/port
Specifies the uplink Ethernet port.
to stack-id/slot/port
Specifies a range of Ethernet ports.
downlink ethernet stack-id/slot/port
Specifies the downlink Ethernet port.
Modes

Global configuration mode

Usage Guidelines

Each uplink utilization list consists of the following:

  • Utilization list number (1, 2, 3, or 4).
  • One or more uplink ports.
  • One or more downlink ports.

Each list displays the uplink port and the percentage of that port's bandwidth that was utilized by the downlink ports over the most recent 30-second interval.

You can configure up to four bandwidth utilization lists.

You can specify a list or range of ports as uplink or downlink ports.

The no form of the command removes the uplink utilization list.

Examples

The following example configures an uplink utilization list. 

device(config)# relative-utilization 1 uplink ethernet 1/1/1 downlink ethernet 1/2/2 to 1/3/2
Parent topic: Commands O, P, Q, R, and Sa through Sh