Configuring SDVoE using the multicast sdvoe Command
The following task enables SDVoE in a
network, as illustrated in the Enabling SDVoE using the
multicast sdvoe Command figure. Switch 1 and Switch 2 have manually configured edge ports and fast
leave is enabled only on these ports. IGMP snooping is enabled in passive mode for
Switch 1 and
Switch 2. SDVoE is configured for multicast packets in the VLAN. No edge ports are
configured
for the Querier switch. IGMP snooping is enabled in active mode for the Querier switch
so that
queries are generated.
Note: Edge-ports should be configured so that fast-leave can be enabled only on these
ports.
Note: Querier switches do not need to have
edge-ports configured as querier switches are generally used to connect to other switches.
- On switch 1, enter global configuration mode.
- Configure a VLAN dedicated to the SDVoE application and add ports to it.
- Set the IGMP mode to passive for the VLAN.
- Enable fast leave on edge-ports only.
- Enable SDVoE for multicast packets in the VLAN.
- For the Querier switch, enter global configuration mode.
- Configure a VLAN dedicated to the SDVoE application and add ports to it.
- Set the IGMP mode to active.
- Configure the source IPv4 address to be used in every query.
- Enable SDVoE for multicast packets.
- On switch 2, enter global configuration mode.
- Configure a VLAN dedicated to the SDVoE application and add ports to it.
- Set the IGMP mode to passive for the VLAN.
- Enable fast leave on edge-ports only.
- Enable SDVoE for multicast packets in the VLAN.
The following example configures SDVoE in a
network using the multicast
sdvoe command.
Switch 1: Switch-1# configure terminal Switch-1(config)# vlan 11 Switch-1(config-vlan-11)# tagged ethernet 1/2/6 ethernet 3/2/7 lag 1 Switch-1(config-vlan-11)# multicast passive Switch-1(config-vlan-11)# multicast fast-leave-v2 edge-ports Switch-1(config-vlan-11)# multicast sdvoe Querier Switch: Querier# configure terminal Querier(config)# vlan 11 Querier(config-vlan-11)# tagged lag 1 lag 2 Querier(config-vlan-11)# multicast active Querier(config-vlan-11)# multicast querier-address 3.3.3.3 Querier(config-vlan-11)# multicast sdvoe Switch 2: Switch-2# configure terminal Switch-2(config)# vlan 11 Switch-2(config-vlan-11)# tagged ethernet 1/3/4 ethernet 3/3/2 lag 2 Switch-2(config-vlan-11)# multicast passive Switch-2(config-vlan-11)# multicast fast-leave-v2 edge-ports Switch-2(config-vlan-11)# multicast sdvoe