`tunnel destination`

Configures the destination address for a specific tunnel interface.

Syntax

tunnel destination { ip-address | ipv6-address }

no tunnel destination { ip-address | ipv6-address }

Command Default

No tunnel interface destination is configured.

Parameters

Modes

Interface tunnel configuration mode

Usage Guidelines

ICX 7150 devices do not support tunnels.

You must ensure that a route to the tunnel destination exists on the tunnel source device and create a static route if necessary.

The no form of the command removes the configured destination for the tunnel interface.

Examples

The following example configures the IP address 10.1.2.3 as the destination address for a specific tunnel interface.

device# configure terminal
device(config)# interface tunnel 3
device(config-tnif-3)# tunnel destination 10.1.2.3

History

Release version	Command history
08.0.41	This command was introduced.
08.0.70	This command added support for IPv6 addressing for IPsec tunnels.

tunnel destination