Search Results: "icx 7450"

(30W) None None None None 802.3at Type-2 No No ICX 7250-48P 740 (internal PSU) + 360 x 2 (with EPS) 1 to 48 (30W) No No ICX 7450-24P 748 x 2 (two AC PSUs) 258 x 2 (two DC PSUs) 9 to 24 (30W) 1 to 8 (60W) 1 to 8 (95W) 1 to 8 1 to 8 802.3at Type-2 No No ICX 7450-48P 9 to 48 (30W) No No ICX 7450-32P 9 to

, ICX 7450 and ICX 7250 devices before enabling Ethernet loopback. You must configure the ethernet loopback test-mac command on ICX 7450 and ICX 7250 devices before enabling Ethernet loopback. In other supported platforms, configure the ethernet loopback test-mac command only if you require the port to

, ICX 7450 and ICX 7250 devices before enabling Ethernet loopback. You must configure the ethernet loopback test-mac command on ICX 7450 and ICX 7250 devices before enabling Ethernet loopback. In other supported platforms, configure the ethernet loopback test-mac command only if you require the port to

interface. MACsec commands are supported only on ICX 7450, ICX 7650, and ICX 7850 devices. The pre-shared key is required for communications between MACsec peers. The following example configures MKA group test1 and assigns the MACsec pre-shared key with a name beginning with 96437a93 and with the

. MACsec commands are supported on ICX 7450, ICX 7550, ICX 7650, and ICX 7850 devices. For a MACsec channel to be created between two ports, both ports and devices designated must have MACsec enabled and configured. The enable-mka ethernet command enables MACSec licensing on the specified interface

, ICX 7450 and ICX 7250 devices before enabling Ethernet loopback. You must configure the ethernet loopback test-mac command on ICX 7450 and ICX 7250 devices before enabling Ethernet loopback. In other supported platforms, configure the ethernet loopback test-mac command only if you require the port to

port. MACsec commands are supported only on ICX 7450, ICX 7650, ICX 7850 devices. For a MACsec channel to be created between two ports, both ports and devices designated must have MACsec enabled and configured. The enable-mka ethernet command enables MACSec licensing on the specified interface. If the

command was introduced. 08.0.30 Support for this command was added on ICX 7450 devices. 08.0.70 Support for this command was added on ICX 7650 devices. 08.0.90 Support for this command was added on ICX 7850 devices.

for ICX 7750, ICX 7450, and ICX 7250 devices. num Specifies the time, in seconds, the device should wait before stopping traffic to a port when a leave message is received The range is 60 through 3600 seconds. Global configuration mode The no form of this command restores the default mcache age-out

specified syslog messages and traps. This command is supported on the Ruckus ICX 7450, with an FPGA-based add-on crypto card. The following example configures syslog generation for IPsec events. device(config)# logging enable ipsec Release version Command history 08.0.50 This command was introduced